23
English
IDE connector
The IDE1 connector supports IDE hard disk drives, optical disk drives, and other
IDE devices.
Important: If you install two IDE devices on the same cable, you
must configure the drives separately to master / slave mode by
setting jumpers. Refer to IDE device's documentation supplied by
the vendors for jumper setting instructions.
Serial ATA connector: SATA1~6
The six serial ATA connectors (SATA1-6) is a high-speed Serial ATA interface
port. Each connector can connect to one Serial ATA device.
Important: Please do not fold the Serial ATA cable into 90-degree angle.
Otherwise, data loss may occur during transmission.
To Next Page
Loading...
