67
English
a In the RAID Mode box, select the mode you want — either Mirroring,
Stripe, Spanning, Stripe Mirroring, or RAID 5.
b In the Stripe Block
box, enter the stripe block size. It is recommended
to leave this value at the default Optimal, which is 64 KB, but the
values can be between 4 KB and 128 KB (4, 8, 16, 32, 64, 128 KB).
Note: Stripe block size selection is not available for Mirroring or Spanning
RAID arrays.
c In the Free Disks section, select a disk and click the arrow key to move
it to the Array Disks section.
d Continue until all disks that you want to use as RAID array appear in
the Array Disks section.
e Press F7.
To Next Page
Loading...
