Machine Maintenance Procedures 3-19
WLAN (Wireless Local Area Network) Module Removal 0
Prerequisite:
Battery Pack Removal
1. Find WLAN module (C) on the top assembly. Refer to Figure 3-7.
2. Disconnect WLAN antenna (B) connected to WLAN card (Figure 3-11).
3. Remove one (1) screw (A) securing the WLAN module in place (Figure 3-11).
Figure 3-11. WLAN Module
4. Remove WLAN module from mainboard connector (D) (Figure 3-12).
Figure 3-12. Removing the WLAN Module
ID Size Torque Quantity Screw Type
A M2.5*3I 2.0±0.2KGF/CM 1
To Next Page
Loading...
