Aspire Z3760 / Z3761 / Z5760 / Z5761 AIO Computer Service Guide 53
4. Gently lift the processor out of its socket.
Removing the Memory Modules
1. Remove the wall mount plate by following the procedure described on page 43.
2. Open the holding clips securing the memory modules (a), then remove the memory modules from the
DIMM slots (b).
IMPORTANT When installing a processor:
• Note the golden arrow on the corner to make sure the processor is properly oriented over
the socket.
• Moisten a soft cloth with isopropyl alcohol and clean the processor die to remove any
thermal grease residue. Wipe the die surface several times to make sure that no particles
or dust contaminants are evident. Allow the alcohol to evaporate before continuing. Apply
just enough thermal grease to evenly coat the surface of the processor die.
A circuit board that is >10 cm
2
has been highlighted with a yellow rectangle as shown in the
above image. Follow local regulations for disposing this type of circuit board.
To Next Page
Loading...
