Acer AT3705-MGW - Changing Channels; Adjusting the Volume

English
13
2
Setup Wizard
Step 5. Scan for analog channels.
Step 6. Setup is now complete. You are ready to begin watching TV.
If you leave the setup process before it is complete, you will be given a choice of options:
1. Resume setup
2. Resume setup at next startup
3. Exit and don't remind me
Select an option and press
OK to exit.
3
Changing channels
RECALL
ENTER
1 2 3
4 5
6
7 8
0
9
ENTER
1 Press 0-9 on the remote control to select a channel. The
channel changes after 2 seconds. Press ENTER to select the
channel immediately.
CH/PG
2 Pressing the channel (CH) up/down button on the remote
control will also change the channel.
4
Adjusting the volume
VOL
Adjust the volume level using the VOL +/- button on the
remote control.
Setup may vary due to local broadcast differences.