OSD navigation
Many of the advanced settings and adjustments are available through using the OSD (onscreen display) menus, as shown in the
example screenshot below.
Basic operations required to navigate these menus (Picture, Audio, Channel management, Settings, Options, Empowering) are
described in this section. The first time you access the OSD, you will be asked to choose your language settings.
There are six main OSD menus. These are: Picture, Audio, Channel management, Settings, Options and Empowering.
Use the following method to navigate these menus.
1
Press the MENU button on the remote control or the Menu button on the control panel.
2
Select your desired menu by using the left and right sides of the directional pad to switch between
the five menus.
3
Use the directional pad to interact with the menu. The up/down directions will scroll through the
menu options, while left/right will adjust the different settings (for example, in the Picture menu,
settings such as brightness, contrast, etc.). If there are no further adjustments, hold down Enter on
the remote control for more than two seconds to save the settings.
You can also interact with these menus using the front panel controls. Please see "Front panel view" on page 6 for
details.
Navigating the OSD with the remote control
DISPLAY MUTE
TV
RECALL
MENU CH LIST
BACK EPG
SWAP ACTIVE POSITION
SIZE/MODE
TELETEXT
MPX
HOLD SIZE SUBTITLE
VOL
PIP/PBP/POP
CH/PG
ENTER
AV SCART
PC
SLEEP WIDE
ZOOM ROTATE
SLIDE
OPTION
SRS/BBE CARD/MGW
1 2 3
4 5 6
7 8
0
9
OK
To Next Page
Loading...
