Acer G205H - Page 49

- 49 -
5.4.3 OSD Message
Item
Description
Auto Config
Please Wait
When User Press Hot-Key “Auto”, will show this message, and the monitor do the auto config
function.
Input Not
Supported
When the Hsync Frequency, Vsync Frequency or Resolution is out of the monitor support range,
will show this message. This message will be flying.
Cable Not
Connected
When the video cable is not connected, will show this message. This message will be flying.
No Signal
When the video cable is connected, but the is no active signal input, will show this message,
then enter power saving.
Please Wait
After user trigger the reset function, system will show this message to notice user the reset is in
proceeding