3. Select [Edit]/[Preferences] /[Communications] to check USB in [Projector Interface].
4. Click [USB Device Identification].
5. Set the items on the [Vendor 0x451, Product 0x2000 ].
6. Click [OK].
7. Move the cursor to [Flash Loader] on the Project window of [DLP Composer Lite]. (The
[Flash Loader] screen will appear.)
8. Click [Browse] and select where the firmware [xxxxxxxxx.img] is for download.
9. Make sure [Skip Boot Loader Area] is with a check.
10. Press Menu and Power buttons cons tantly within ten seconds after insert the USB Burning
Cable and power Cord. Power LED will start flashing. That indicates the projector is in the
download mode. At this moment, you can release these two buttons.
11. Click [Start Download]. When the dialog box is di splayed, click [Yes].
To Next Page
Loading...
