K
Katelyn PatelSep 13, 2025
How to fix reversed image on Acer P1183?
- MMary CobbSep 13, 2025
Select "Image --> Projection" on the OSD and adjust the projection direction.
To Next PageTo Next PageHow to fix reversed image on Acer P1183?
Select "Image --> Projection" on the OSD and adjust the projection direction.
Why does Acer P1183 Projector lamp burn out or make a popping sound?
When the lamp reaches the end of its useful life, it will burn out and may make a loud popping sound. If this happens, the projector will not turn on until the lamp module has been replaced. To replace the lamp, follow the procedures in the "Replacing the Lamp" section.
How to fix partial or scrolling image on Acer P1183 (for PC)?
Try pressing "RESYNC" on the remote control or control panel. If the image is incorrectly displayed, open "My Computer," then the "Control Panel," and double-click the "Display" icon. Select the "Settings" tab and verify that your display resolution setting is lower than or equal to WUXGA-RB (1920 x 1200). Click the "Advanced Properties" button. If the problem persists, change the monitor display you are using and follow these steps: Verify that the resolution setting is lower than or equal to WUXGA-RB (1920 x 1200). Click the "Change" button under the "Monitor" tab. Click "Show all devices". Next, select "Standard monitor types" under the SP box, and choose the resolution mode you need under the "Models" box. Verify that the resolution setting of the monitor display is lower than or equal...
General
