8
English
Powering On the Projector
1. Remove the lens cap.
2. Ensure that the power cord and signal cable are securely connected.
3. The “Power/Standby” indicator will flash. And press the “Power/Standby”
button again to start on your projector. The startup screen will display and
count down for 20 seconds and the Power/ Standby indicator will light solid
amber.
4. Turn on your source (computer, notebook, or video player ,etc.). The projec-
tor will detect your source automatically.
* If the screen displays “No Signal” , please make sure the signal cables
are securely connected.
* If you connect multiple sources at the same time, use the “Source”
button on the Remote Control or Panel Control to switch.
* Turn on the projector first and then the computer.
Power On/Off the Projector
Lens cap
Power /
Standby
To Next Page
Loading...
