Acer PD525 Series - Powering On;Off the Projector; Powering on the Projector

13
... English
Introduction
Powering On the Projector
1. Removethelenscap.
2. Ensurethatthepowercordandsignalcablearesecurely
connected.ThePowerLEDwillash
red
.
3. Turn on the lamp by pressing “Power” button on the control
panel

,andthePowerLEDwillturn
blue
.
4. Turnonyoursource(computer,notebook,videoplayer,
etc.). The projector will detect your source automatically.

If the screen displays “Lock” & “Source” icons, it means the pro-
jector locks on this source type and there is no such type of input
signal found

If the screen displays “No Signal”, please make sure the signal
cables are securely connected.

If you connect multiple sources at the same time, using the
“Source” button on the remote control or control panel to
switch.
Powering On/Off the Projector

Turn on the projector
rstandthenthesignal
sources.
Power
1