Acer PD525 Series - Replacing the Lamp

49
... English
Appendices
Replacing the lamp
The projector will detect the lamp life itself. It will show you a
warning message “Lamp is approaching the end of its useful
life in full power operation. Replacement Suggested!” When
youseethismessage,changingthelampassoonaspossible.
Makesuretheprojectorhasbeencooleddownforatleast30
minutes before changing the lamp.
Warning:
Lamp compart-
ment is hot! Allow
it to cool down
before changing
lamp!
Warning:
To
reduce the risk of
personalinjury,do
not drop the lamp
module or touch
the lamp bulb. The
bulb may shatter
and cause injury if
it is dropped.
Lamp Changing Procedure:
1.TurnthepowerofftheprojectorbypressingthePower
button.
2. Allowtheprojectortocooldownatleast30minutes.
3. Disconnect the power cord.
4. Useascrewdrivertoremovethescrewfromthecover.

5. Push up and remove the cover.

6. Removethe2screwsfromthelampmodule.

7.Pulloutthelampmodule.

To replace the lamp module, reverse the previous steps.
1
3
4
2