English
53
USING THE PROJECTOR
Specication for “RS232 by TELNET”:
1. Telnet: TCP.
2. Telnet port: 23 (for more detail, kindly please get contact with the service agent or team).
3. Telnet utility: Windows “TELNET.exe” (console mode).
4. Disconnection for RS232-by-Telnet control normally: Close
5. Windows Telnet utility directly after TELNET connection ready.
– Limitation 1 for Telnet-Control: there is less than 50 bytes for successive network payload for
Telnet-Control application.
– Limitation 2 for Telnet-Control: there is less than 26 bytes for one complete RS232 command for
Telnet-Control.
– Limitation 3 for Telnet-Control: Minimum delay for next RS232 command must be more than 200 (ms).
Info menu
Note: Functions vary depending on model denition.
Info menu
View the projector information as listed below:
Serial Number
Source
Resolution
Refresh Rate
Display Mode
Power Mode (Standby)
Light Source Hours
Network Status
IP Address
Brightness Mode
FW Version
To Next Page
Loading...
