Chapter 7 94
Step 7:Select two HDDs as "Source Hard Drive".
Picture15
Step 8:At least select two HDD as Menber Hard Drive(s).
Step 9:Specify Volume Size then press "next".
Step 10:Press "next" to finish setup and start create RAID 10.
Step 11:It may takes half and hours to create RAID 10.After create completely,it will ask to reboot to finish
create RAID10.
2-5:Create a“RAID Ready” System into" RAID 0" with two Hard Drives by ‘Create RAID Volume ’.
Step 1:Install WIN7 OS with one SATA HDD.
Step 2:Shut down the system,then add another two serial ATA hard drives in the system.
Step 3:Boot to OS desktop, open the Intel® Matrix Storage Console.
Step 4:Click on the by‘Create RAID Volume’ to create a RAID volume.
Picture16
To Next Page
Loading...
