This page only be visible in factory mode
R,G,B OFFSET :
Adjust current RGB cut off level
R,G,B GAIN :
Adjust current RGB Driver value.
SPREAD :
Adjust chip set internal frequency spread
effect for EMI testing.
This page only be visible in factory mode
AUTO BURN :
Use the chip set internal pattern for hot
running monitor panel and inverter.
AUTO COLOR :
Perform Auto Balance measurement by
chip set internal signal. And reference
these values to initial all other color
temperature detail parameters.
COLOR UPDATE:
Force presently R,G,B offset and gain
parameters update to currently
temperature memory address.
FACTORY RESET :
Recall to factory setting and power off
immediately.
VERSION :
Display F/W version and panel vender .
To Next Page
Loading...
