Acer V226HQL

ACER V226HQL
11
S3
Assemble the lamp wire
Insert the big connector of the lamp wire to the P/BD .
Stick 2 tape to fasten the lamp wire and one AL-Tape on SHD as the picture.
S4
Assemble LVDS cable
Insert the LVDS cable to the Panel and stick one tape on LVDS cable.
S5
Assemble SHD
Lock the Hexagonal screws and DP screw as picture 1.
Use jig to put the SHD in correct position on Panel. Take off the jig and stick two AL
tapes as picture 2.
PICTURE 1 PICTURE 2
S6
Assemble RC, stand and base
Assemble the RC with screw.
Assembly the Stand and the Base to Monitor
NOTE: Circuit boards >10 cm² has been highlighted with the yellow rectangle as above image shows. Please
detach the Circuit boards and follow local regulations for disposal.