Acer V227Q

ACER V227Q
12
S5
Assemble the Ctrl PCBA on
RC.
Assemble FFC Ctrl to the Ctrl PCBA as picture 1. Assemble Control BD to the RC.
Tear off the gums on the FFC Ctrl and stick the FFC Ctrl on the RC.
Stick 1 piece adhesive tape on the point of inflexion of the FFC Ctrl as picture 2.
PICTURE 1 PICTURE 2
S6
Assemble the speaker on
the MF
Insert the speaker connect to the I/F BD as the picture. Arrange the wire of the speaker
(Attention: Keep the speaker wire straight, and the middle of the speaker wire is not
allowed to be placed on the step of the panel.)
Tear four BOPP tapes and stick them on the back of the panel to fasten the speaker
wire as the picture.
S7
Assemble the RC, stand and
base
Insert the FFC Crtl into the BD. Stick the FFC Ctrl on the SHD.
Assemble the RC to the MF. Lock RC screw.
Assemble the column and base on the RC.
NOTE: Circuit boards >10 cm² has been highlighted with the yellow rectangle as above image shows.
Please detach the Circuit boards and follow local regulations for disposal.
Control BD
Control BD