Acer V227Q

ACER V227Q
7
4. Disassembly and Assembly SOP
V227Q
4.1 Disassembly Procedures
Preparation before disassemble
1.Clean the room for disassemble
2.Identify the area for monitor
3.Check the position that the monitors be placed and the quantity of the monitor ;prepare the area for material flow;
according to the actual condition plan the disassemble layout
4.Prepare the implement, equipment, materials as bellow:
1) working table
2) Screw-driver
3) knife
4) glove
5) cleaning cloth
6) ESD protection
After unplugging the power cord, the power board still have power energe. Please pay attention
when disassembling/assembling.
S1
Disassemble the
RC(Rear Case), stand
and base
Before Disassembling & Assembling, monitor need to be put on the sponge and
the Insulation glove must be wore during the process
Disassemble base and column from the RC. Unlock RC screw.
Disassemble RC from monitor and Disassemble FFC CTRL from the PCBA.
S2
Disassemble FFC Ctrl
from the PCBA.
Tear off the adhesive tape from the RC. Tear off the FFC CTRL on the RC as picture 1.
Disassemble the CTRL BD from the RC. Disassemble the FFC CTRL from the CTRL BD
as picture 2.
PICTURE 1 PICTURE 2
CTRL BD
CTRL BD
Disassemble
FFC