21
Note: "H. Position", "V. Position", "Frequency" and "Tracking" functions
are not supported under video or HDMI mode.
Note: "HDMI Color Range" and "HDMI Scan Info" are only available when
the input signal is HDMI.
Digital Zoom
Out
Sets the default size of the projected image. You can further
zooms in or out the image by pressing . Using the
functions of Digital Zoom Out and Image Shift together helps
you fit the projected image full screen without adjusting the
existing ceiling mount settings.
Image Shift
Shifts the projected image by pressing . When Native
Resolution is WUXGA, this functions is only available when
the setting of Digital Zoom Out (Install) is less than 1.0.
H. Position
(Horizontal
Position)
• Press to move the image left.
• Press to move the image right.
V. Position
(Vertical
Position)
• Press to move the image down.
• Press to move the image up.
Frequency
Changes the projector’s refresh rate to match the frequency
of your computer’s graphics card. If you experience a vertical
flickering bar in the projected image, use this function to
correct it.
Tracking
Synchronizes the signal timing of the display with the
graphics card. If you experience an unstable or flickering
image, use this function to correct it.
HDMI Color
Range
Adjusts the color range of the HDMI image data to prevent
color display error.
• Auto: Automatically adjusts the color range by
information from the player.
• Limited Range: Processes the input image as limited
color range data.
• Full Range: Processes the input image as full color range
data.
HDMI Scan Info
Adjusts the overscan ratio of the HDMI image on screen.
• Auto: Automatically adjusts the overscan ratio by
information from the player.
• Underscan: Always no overscan on the HDMI image.
• Overscan: Always keep overscan on the HDMI image.
To Next Page
Loading...
