English
1. Press the MENU key to open the OSD.
2. Toggle the button to the up or down to select System from the OSD.Then toggle to the
right to
navigate to the element you wish to adjust and press the button to enter it.
3. Toggle to the left or right to control functions.
4. Input: Select the source from HDMI1, HDMI2, DP, TypeC.
5. Auto Source: The default is “On”, which can support auto search for signal source in
order.
-----------------------------------------------------------------------------------------------------------
Note: Surround application must set Auto Source is “Off”.
6. Wide mode: You can select which screen aspect you are using. The options are Aspect
and Full.
7. Hot Key Assigment: Select the function of shortcut key 1(Modes, Volume, Brightness,
Gamma, Contrast, Low Blue Light, Over Drive
) and shortcut keys 2 (Modes,
Volume, Brightness, Gamma, Contrast, Low Blue Light, Over Drive).
8. DDC/CI: Allows the monitor settings to be set through the software on the PC.
-----------------------------------------------------------------------------------------------------------
Note: DDC/CI, short for Display Data Channel/Command Interface, which allows
monitor controls to be sent via software.
System
9. HDMI Black level: Select to set HDMI black level.
10. Quick start mode: Select Off or On. Turn on to speed up boot speed.
Mode - Standard
HDMI1
Picture
Color
Input
Audio
OSD
On
DP Format
System
Wide Mode
DDC/CI
Hot Key Assignment
Normal
Auto Source
HDMI Black Level
On
DP1.4
Full
Quick Start Mode
Off
Mode - Standard
C-Type
Picture
Color
USB Port Seiect
Audio
OSD
On
Ambient Light
System
HDMI 2.1
DSC
off
MAX Refresh Rate
Power-off
USB charge
144Hz
Off
On
11.
12.
Ambient Light：Select Off or Running Light/Flashing/Breathing/
Blue/Red。
Power-off USB charge：Select Off or On。
16
To Next Page
Loading...
