achilles A23S - OPERATION OF TRACK WIDTH CHANGE AND DOZER; Operation of the Track Width

36
OPERATION OF TRACK WIDTH
CHANGE AND DOZER
CAUTION
To avoid personal injury:
 Do not operate in narrow track
width (1120mm)], it makes risk
of the excavator tipping over,
operate always in standard track
width [49in. (1240mm)], except
to pass through narrow space on
a even ground.
 For changing the track width or
using the dozer, set the
track width change/ dozer
select lever fully. If not, the
excavator may unintentionally
move.
 Operation of the Track Width
1. Set the track width change/dozer select
lever to the “Track width change”
position (B).
2. Push the control lever forward.
... The track width increases (990 mm to
1300 mm)].
Pull the control lever backward.
... The track width reduces (1300 mm to
990 mm)].
(1) Control lever (A) “Increase”
(B)“Reduce”
3. After track width change, be sure to set
the track width change/dozer select lever
to the “Dozer” position (A).
3