10
10. PROMPTS AND ERROR MESSAGES
Caution: If an error message appears, first switch off the appliance and then disconnect from
the power supply. Check the connections, water supply and drain lines as well as the stop valves.
Then connect the appliance to the power supply again. If the error message continues, contact
an authorised service partner immediately.
PROMPTS AND ERROR MESSAGES
E1 Check rinsing system
E2
Check drain system – timeout
E3
Check boiler heating – timeout
E4
Check tank filling – timeout
E5
Check tank sensor – value too low
E6
Check tank sensor – value too high/short circuit
E7
Check boiler sensor – value too low
E8
Check boiler sensor – value too high/short circuit
E9
Check boiler filling – timeout
E21
Check rinsing – timeout
E22
Check tank heating – timeout
E98 Check soft start – malfunction
E99
Motherboard / connection error
SAF ESF
Safety thermostat triggered
SAF ESL
Check tank level – value too high/low
SLt
Salt level low – refill soon
dEt
Detergent suction tube empty level
brL
Rinsing agent suction tube empty level
Sru
Service/cartridge replacement due
Abr Abort cycle – restart
reG
Resin regeneration in the background
To reset the service cycle counter: switch off the machine, open
the door and press and hold down all three buttons for 4 seconds.
RZ_Bedienungsanleitung_bluebee_4Sprachen_2c.qxp_Layout 1 10.03.20 16:44 Seite 10
To Next Page
Loading...
Need help?
General
