- 28 -
All Reset
Special Function
Enter the control menu and select Special Function, press ENTER. Use the UP/DOWN
button to select USB Upgrade, Send Upgrade, Firmware Restore or Factory Settings.
USB Upgrade
Send Upgrade
Select Send Upgrade, press ENTER.
If you wish to send upgrade files from this fixture to next fixtures to
upgrade their firmware, select Yes. Once Yes is selected, the display of
this fixture will show “Sending Packet, Please Wait...” while the display of
next fixtures will show “Upgrading, Please Wait...”. A percentage bar will
also be displayed. After the update is complete, fixtures will perform a
reset (this can take some time).
If you do not wish to send anything, select No. Confirm your selection
with ENTER.
To exit the menu, press MENU, or wait 30 seconds.
Select USB Upgrade, press ENTER.
The upgrade files are displayed. (See the ‘Updating Software’ section for
details.)
To exit the menu, press MENU, or wait 30 seconds.
Select All Reset, press ENTER.
Use UP/DOWN button to select No or Yes (the device will run built-in
program to reset all to their home positions), confirm your selection with
ENTER.
To exit the menu, press MENU, or wait 30 seconds.
To Next Page
Loading...
