Select Firmware Restore, press ENTER.
If you wish to restore fixture’s firmware, select Yes. Once Yes is selected,
the display will show “Upgrading, Please Wait...”. A percentage bar will
also be displayed. After the update is complete, the fixture will perform a
reset (this can take some time).
If you do not wish to restore anything, select No. Confirm your selection
with ENTER.
To exit the menu, press MENU, or wait 30 seconds.
Select Factory Settings, press ENTER.
If you wish to reset the device to the factory settings, select Yes. If you
do not wish to reset anything, select No. Confirm your selection with
ENTER.
To exit the menu, press MENU, or wait 30 seconds.
To Next Page
Loading...
