- 31 -
Updating Software：
1. Download the software update files from the ACME website.
2. Copy the software files to a compatible USB flash drive.
Note: To avoid the risk of uploading the wrong file to the fixture, make sure that there are no
other files on your flash drive.
3. Disconnect DMX and Ethernet connections and power the fixture on.
4. Insert the USB flash drive into the FIRMWARE UPGRADE port located on the rear panel of
the fixture.
5. Locate “Special Function” within the system menu and press ENTER. Scroll to the “USB
Upgrade” submenu and press ENTER.
6. Two software files will be displayed as downloaded earlier. Highlight the first file (V00)
and press ENTER. Select “Yes” to begin the first of two updating processes. Once Yes is
selected, the display will show “Copying Files, Please Wait...”. After copying is complete, the
display will show “Upgrading, Please Wait...”. A percentage bar will also be displayed.
7. After the first update is complete, the fixture will perform a reset (this can take some time).
8. Once the reset is complete, scroll to the “Special Function” menu again and press ENTER.
Scroll to the “USB Upgrade” submenu and press ENTER.
9. Highlight the second file (Vxx) this time and press ENTER. Select “Yes” to begin the second
and final updating process. Once Yes is selected, the display will show “Copying Files, Please
Wait...” again. After copying is complete, the display will show “Upgrading, Please Wait...”. A
percentage bar will also be displayed.
10. After the second update is complete, the fixture will perform another reset (this can take
some time as well).
11. Remove the USB flash drive.
12. After the reset process is complete, check the new software version to confirm it is
updated to the most recent software.
To Next Page
Loading...
