Check whether the position of the gobo wheel 1/2 where the magnet
is installed falls off or is damaged.
Check whether there are obstacles in the gobo wheel 1/2 operating
range.
Check whether the Hall element on the gobo wheel 1/2 is damaged.
Check whether the lead connecting the Hall element on the gobo
wheel 1/2 and the PCB board is in poor contact or disconnected.
Check whether the motor on the gobo wheel 1/2 is damaged.
Check whether the related circuit of the motor drive board on the
gobo wheel 1/2 is damage.
Check whether the position of the animation wheel where the
magnet is installed falls off or is damaged.
Check whether there are obstacles in the animation wheel operating
range.
Check whether the Hall element on the animation wheel is damaged.
Check whether the lead connecting the Hall element on the
animation wheel and the PCB board is in poor contact or
disconnected.
Check whether the motor on the animation wheel is damaged.
Check whether the related circuit of the motor drive board on the
animation wheel is damage.
To Next Page
Loading...
