6.19
ALIGNMENT
If the machine has been adjusted vertically in
the shimming screen, go directly to alignment
in the horizontal direction.
If the machine has not been adjusted in the
shimming screen, alignment in the vertical
direction must be done first.
Vertical direction
Rotate the shafts to the 12 or 6 o’clock
position to adjust in the vertical direction. The
angle guide helps you to reach the right
position.
Adjust the machine vertically until the values
for both angular and parallel alignment are
within tolerance. The arrows by the feet show
in which direction the machine should be
moved.
To Next Page
Loading...