TEFLON LINERS INSTRUCTIONS
Some ovens may be equipped with a PTFE (non-stick) coated liner material to enable easy cleaning of the
oven using an approved cleaner. The life expectancy of the liners depends on how much you use your oven.
• Heavy usage – 2-5 months
• Medium usage – 5-8 months
• Light usage – 8-12 months
The liners are supplied cut to size for each oven cavity surface (Floor and rear cavity walls do not require
liners). Kits are available based upon individual model numbers.
Check that you have the correct items available before starting the application process.
No special tools are required to apply the liners. The oven must be cool and clean of all grease and debris
before applying the liners to the cavity.
The liners are supplied with a backing sheet which must be removed during the application process.
Step 1 Remove the internal rack.
Step 2 The oven interior must be clean and free from grease and oven residue. If cleaning is necessary use an
approved cleaner to remove residue; rinse and wipe the surface dry. DO NOT use abrasive scouring pads to
clean ceramic top cover. Avoid using caustic cleaning products or those containing ammonia, phosphates,
chlorine, sodium or potassium hydroxide (lye). If needed fully remove grease, first spray on towel, then wipe
down oven cavity.
Step 3 Identify the sheet cut to fit each cavity surface (left, right, rear, floor and door). Peel the backing
sheet from one edge by approximately 1 inch (3 cm) and carefully apply to the appropriate area.
Step 4 Gently pull away the backing sheet from the liner while pressing the liner into position using care to
minimize any air pockets or bubbles between the liner and the cavity.
Step 5 Repeat step 4 for the remaining liners.
Liner Removal if Liner was Installed Previously:
Step 1 Clean oven cavity of heavy grease and debris.
Step 2 Lift one corner of the used liner sheet and gently pull away from surface.
Step 3 Ensure that the surfaces are free from burned on residue and left over adhesive before the new liners
can be applied. If any grease or oven residue remains, use an approved cleaner to remove, rinse and wipe
the surface dry. DO NOT use abrasive scouring pads to clean ceramic top cover. Avoid using caustic cleaning
products or those containing ammonia, phosphates, chlorine, sodium or potassium hydroxide (lye).
Step 4 Apply new liners following "Application" directions.
To Next Page
Loading...
