To Next PageTo Next Page
Need help?Do you have a question about the ACP MXP22QTT and is the answer not in the manual?
ACP disclaimer for service procedures. Emphasizes qualified technicians and reviewing info before repairs.
To avoid severe personal injury or death, disconnect power before servicing to avoid electrical shock.
Explains DANGER, WARNING, CAUTION symbols and their meanings for hazard identification.
Lists 13 safety precautions for servicing the microwave to maintain safety and prevent radiation exposure.
General safety precautions for using electrical equipment to reduce risks of burns, shock, fire, or injury.
Summarizes key safety warnings for oven operation, including fire and liquid hazards.
Steps for unpacking, countertop placement, and installing the oven rack.
Details required clearances around the oven for proper airflow and operation.
Covers oven clearances, turning on, preheating, and using preprogrammed cooking pads.
Guide for using manual cooking when specific time and power levels are needed for experimenting with food.
Procedures for saving, editing, and moving recipes within the oven's menu system.
Procedure for loading firmware or configuration files onto the oven using a USB flash drive.
Steps to connect the oven to Wi-Fi and a computer for network access and recipe transfer.
Guide to accessing and modifying various user options to customize oven operation.
Step-by-step guide for updating the oven’s firmware using a USB flash drive.
Covers daily cleaning, safety precautions, supplies, and initial oven preparation.
Detailed steps for cleaning the oven interior, including removing racks, elements, and surfaces.
Diagram illustrating the external construction of the oven, showing panels and filters.
Diagram labeling key high-voltage components like magnetrons, transformers, and fuses.
Diagram labeling internal components like circuit boards, power relay, limiter, triac, and sensors.
Diagram showing the construction of the oven with a mechanical limiter, labeling parts like HV board and power supply.
Diagram illustrating the assembly of the touch control panel, with numbered components.
Diagram showing the antenna motor, cam, gear assembly, and related parts with notes on assembly.
Information on replacing the ceramic tray, including part numbers and kit contents.
Details on replacing the waveguide, including part numbers and kit contents for AXP22*/MXP22* models.
Guide for applying and removing PTFE coated Teflon liners for easier cleaning, including life expectancy.
Procedures for testing thermal cutouts, diodes, triacs, and capacitors using resistance and voltage checks.
Testing procedures for snubber assemblies, magnetrons, and motors, including resistance and voltage measurements.
Procedure for testing the primary interlock switch, focusing on continuity when the door is open or closed.
Procedures for testing transformers, heating elements, and temperature sensors (RTD).
Testing procedures for relays, wire harness continuity, and power supply board voltages.
Testing procedures for electronic limiters and mechanical thermal cutouts, checking resistance and continuity.
Steps for adjusting and replacing the interlock switch assembly for proper door activation.
Instructions on how to enable PIN code and access the service test mode using a specific PIN.
Accessing oven info and testing magnetrons for amperage and comparison in Service Mode.
Testing magnetrons, heaters, fans, and RTDs for diagnostics and performance checks.
Checking voltage, memory, error history, and displaying the PIN code in Service Mode.
A table listing error codes, their descriptions, and recommended corrective actions for troubleshooting.
Covers test setup, procedure, required equipment, and interpretation of results.
Schematic diagram illustrating the main power distribution and control circuits of the oven.
Comprehensive wiring diagram showing connections between all components, including wire color codes.
Schematic focusing on the power supply, control board, and interlock circuits.
Wiring diagram detailing connections for magnetrons, heaters, motors, and sensors with wire codes.
General