MOB USER MANUAL
9 Y1-03-0283 Rev. C
NOTE: When loading the activation tape, the tape must be positioned between the
arming retainer and activation slide as shown below, or the MOB will fail to deploy.
In all installation scenarios (A – E) below, ensure that the installed MOB is
tethered to the life jacket using either of the tether attachment points (top of
MOB or bottom of MOB) shown in the following images. When attaching the
tether to the life jacket, ensure that the knot used is secure. Also make sure that
the location of attachment will not lead to strangulation of bladder or any other
potential bladder failure.
In all installation methods described below:
Determine the best place for fitment.
Ensure location is not within a heavily tapering section of the bladder.
Ensure that the inflated life jacket will be able to provide a linear pull on the
activation slide, perpendicular to the side of the product and with enough bladder
width protruding to ensure full activation slide removal.
On completion of fitting the MOB, the tape should be tight enough to provide
enough movement when the bladder is inflated to completely remove the slider
from the product. Do not over tighten the tape as this may allow the slider to
become dislodged under repeated movement of the life jacket.
To Next Page
Loading...
