13
第一路继电器输出
First relay output
由通信控制的 DO 输出模式，此时“dLy”为 0 则为电平控制。设置其他
值为自动返回模式。
DO
动作后延时“
dLy
”（单位为
0.01
秒）后自动断开
The DO output mode controlled by the communication, when "dLy" is 0, it is
the level control. Set the other value to auto return mode. DO disconnect
automatically after delay “dLy” (in 0.01 seconds) after action.
第一路直流电参量报警
Alarm of the first DC parameter
第一路直流电参量、联动开关量报警，逻辑为或
Alarm of the first DC parameter and linkage switch, logic is or
联动 DI1 报警
Linkage alarm DI1
联动
DI1
、
DI2
报警，逻辑状态为或
Linkage alarm DI1、DI2,logic is or
第二路直流电参量报警
Alarm of the second DC parameter
第二路直流电参量带开关量报警
Alarm of the second DC parameter with switch
手动复归开启（在主界面按回车键使继电器触点断开，主要用于消音）
Manual reset is turned on (Press the enter key on the main interface to make
the relay contact open, mainly used for silence)
手动复归关闭
Manual reset is turned off
输出延时时间：如果为 DO 输出方式，设置为 0 时，为电平控制方式，非 0 时为脉冲控制方式，
延时设置的时间后断开，延时设置范围 1－255 时，单位：0.01 秒；如果为报警输出方式，延
时设置范围
1
－
9999
时，单位：
1
秒；
Output delay time: If it is DO output mode, when it is set to 0, it is the level control mode; when it is
not 0, it is the pulse control mode, and is disconnected after the setted delay time, the delay setting
range is 1-255, unit: 0.01 seconds; if it is alarm output mode, delay setting range is 1-9999, unit: 1
second;
电压高报警，按百分比进行设置
High voltage alarm, set by percentage
电压低报警，按百分比进行设置
Low voltage alarm, set by percentage
电流高报警，按百分比进行设置
High current alarm, set by percentage
电流低报警，按百分比进行设置
Low current alarm, set by percentage
功率高报警，按百分比进行设置
High power alarm, set by percentage
功率低报警，按百分比进行设置
Low power alarm, set by percentage
零值报警关闭（低报警）
Zero alarm is disabled(Low alarm)
Note: do2 setting is the same as do1.
To Next Page
Loading...
Need help?
General
