710-00002.5
Chapter 6:
M
AINTENANCE
If the charger came with an air filter (located behind the front cover), regularly inspect air filter and clean or replace
as necessary. Location and environmental conditions must be taken into account when determining the
frequency that the filter is cleaned or replaced. The air filter can be blown out or washed in warm soapy
water (the filter must be completely dried prior to reinstall)
Regularly inspect the DC cables for wear. If the DC cables or connectors become worn or damaged, they
should be immediately replaced with a cable of the same rating by qualified personnel.
The following are general guidelines in regard to cleaning or replacing the air filter:
Recommended
Filter Replacement
Cycle
A normal daily operation Conventional Charging basic
material handling of clean product in dry
environments.
Extended operating hours or constant use when Fast
or Opportunity charging in dusty, hot but dry
environments.
All dusty or sandy conditions such as in cement
plants, lumber or flour mills, coal dust or stone-
crushing areas.
Corrosive atmosphere such as in chlorine or salt-sea
air environments.
To Next Page
Loading...
