The reset button is used to restore the factory default settings
of the camera, including the administrator’s password.
To reset the camera, do the following:
a. Loosen the four (4) screws using the bundled hex
screwdriver to remove the cover.
b. Press and hold the reset button for at least 5 seconds or
until the Power LED goes off.
Insert a memory card into this slot for local recording purposes.
See How to Install the Memory Card on page 38 for more
information.
NOTE: Supoorts microSDHC and microSDXC cards.
This jack connects to an audio output device, such as a
speaker. See How to Connect Audio Devices on page 37.
To Next Page
Loading...
