Hardware Manual
9
Physical Description
1) Reset Button
The purpose of reset button is to restore the factory default settings of the camera, including the
administrator’s password.
The reset button can be used for following purposes:
1. The administrator’s password has been forgotten and therefore the camera cannot be
accessed.
2. In case of IP address, mask, or allow/deny filter related issues, resulting with inability to modify
these settings.
3. In case of connectivity issues or abnormal video quality.
How to do the reset properly?
Press and hold the reset button for 5 seconds.
2) Memory Card Slot
Insert a memory card into this slot for local recording. This slot supports microSDHC and
microSDXC standards (card not included in the camera package). For more information on using
the memory card, please refer to the Firmware User Manual.
3) Ethernet Port
Connects to a network using an Ethernet cable.
To Next Page
Loading...
