I have my MyWirelessTV Receiver and Transmitter in the
same room. Why does my source device accept the
command from the remote control twice?
To prevent the source device from getting the IR command twice,
connect your IR Extender cable to the Receiver and hide the IR sensor
from direct line-of-sight.
What is the remote control used for?
e MyWirelessTV remote control is used to congure dierent setups,
such as connecting two Transmitters to a single Receiver. Also, you can
access the MyWirelessTV’s graphical user interface to change system
settings. See the “Remote Control” section of the “Using the
MyWirelessTV Graphical User Interface” chapter for more information.
MyWirelessTV User Manual
31
To Next Page
Loading...
