Sync LED e Sync LED, located on the front of the Transmitter, is
used to display the state of synchronization between the Transmitter
and Receiver(s). If it is blinking or o, the Transmitter is not
synchronized with any Receivers. If it is glowing steadily,
synchronization has been established with at least one Receiver.
Sync Button e Sync button, located on the front of the Transmitter,
is used set up synchronization with a Receiver or Receivers.
Power LED e Power LED, located on the front of the Transmitter, is
used to display the state of the Transmitter’s power. If unlit, the unit is
o. If lit, the unit is on.
Mini USB Port e Mini USB port, located on the front of the
Transmitter, is used to connect a USB stick drive to the Transmitter
when a rmware update is available. See “Updating MyWirelessTV’s
Firmware” for more details. It is also used for the USB backchannel
feature.
Reset Button e Reset button, located on the front of the
Transmitter, is used to reset the transmitter to factory default settings.
MyWirelessTV User Manual
7
To Next Page
Loading...
