I encounter connection failure with the Receiver and my device
can’t connect to it any more.
•
Reboot the Receiver and try connection again. Or, reboot your device
(laptop/Ultrabook/tablet/smartphone) and try connection again.
•
Reboot both the Receiver and your device and try connection again.
•
If you are using a Windows 8.1 operating system, go to Change PC
settings > PC and Devices > Devices > Projectors, remove the prole
of ScreenBeam Pro from your device (PC/laptop/Ultrabook), and try
connection again.
•
If you are using an Android operating system, go to WLAN > WiFi
Direct > Remembered Groups, remove the prole of ScreenBeam Pro
from your device, and try connection again.
I can’t connect to the Receiver with ScreenBeam Conguration
Utility on my device. The Utility can’t nd the Receiver.
In Windows 8.1, you must connect your device to the Receiver at least
one time. In doing so, the prole of the Receiver is saved to your device.
en the Utility on your device can connect to the Receiver.
In Windows 7/8, you must connect your device to the Receiver with Intel
WiDi rst, and then the Utility on your device can connect to the
Receiver.
In Windows 8.1, I can’t adjust the screen size with the ScreenBeam
Conguration Utility. I can’t nd the screen size adjustment
option.
e screen size adjustment option is not available if your device doesn’t
connect to the receiver. You must connect your device to the Receiver
rst, and then launch the Utility and congure the receiver.
!
To Next Page
Loading...
