When I connect the source device to a wireless network (router/
AP), why does the Receiver disconnect automatically?
e source device’s communication channel changes when you connect
your device to a wireless network (router/AP) when the source device is
connected to the Receiver. As a result, the Receiver disconnects from the
source device.
Try connecting your device to the wireless network before connecting it
to ScreenBeam Pro. In this way, the Receiver works on the same channel
with the source device and the wireless network, and no connection
interruption will occur.
My device is running the Windows 8.1 operating system. But the
Add a wireless display menu is not available in Charms > Devices >
Project. What should I do?
If you are running Windows 8.1 and Add a wireless display does not
appear, try the following:
•
For Intel WiDi compatible devices, go to "
http://www.actiontec.com/widi81 "
for the latest soware update.
•
Update your Windows 8.1 via the Windows Update application.
•
Consult your device manufacturer, and update the WLAN adapter
and display adapter of your device to the latest drivers.
!
To Next Page
Loading...
