Accessing the Extender’s GUI
e Extender features an onboard graphical user interface (GUI) that
includes user-congurable settings. Some of these settings should be
accessed by experienced network technicians only.
To congure the network settings of the Extender:
1. Ensure that the Extender is connected to a gateway/modem’s MoCA
coaxial network, and that both devices are powered on.
2. On a computer connected to the same network as the gateway/
modem and Extender, log in to the gateway/modem’s GUI. Find the
list of devices that are connected to your gateway/modem.
3. Find the Extender by its MAC ID from the list of connected devices
or status screen. e MAC ID of the Extender is provided on a sticker
located on the rear panel of the Extender, as shown below.
4. Write down the IP address of the Extender.
To Next Page
Loading...
Need help?
General
