Section 3 Charging and Storing
13
Charging and storing
IMPORTANT: GENEActiv devices that are not in use should be charged every 3 months, and not left charging
longer than necessary.
Allow the GENEActiv device(s) to charge for at least 3 hours before configuring with the software.
The light on the device will flash red while it is charging, and green once it is charged.
When not recording, the battery charge can be checked with a quick press of the button on the device.
A green flash indicates that the device is OK for storage, a red flash or no flash at all means that the device should
be charged (this function is not available if a device has been configured to record).
The battery status indicator in the software user interface is for general information only. To ensure that a device
is fully charged it MUST be left in the cradle until the green light is flashing.
The short flash on the button shows the storage condition of the battery. This DOES NOT indicate that the device is
fully charged.
To Next Page
Loading...
Need help?
General