activTek AP3000 - AP3000 Operation Modes; High Mode Operation Guide; Normal Mode Operation Guide; Away Mode Operation Guide

6 7
OPERATION
1. Adjust the fan speed to your preference, keeping in mind that higher fan speeds will give better results.
2. Using the Normal/High button, set the unit to NORMAL, for typical use, or HIGH, for increased smoke and odor
control.
3. For HIGH MODE, using the PURIFIER UP and PURIFIER DOWN buttons on the remote control, adjust the
puriation level to its lowest setting (250 sq. ft. (23m
2
) for the rst 24 hours of operation, them gradually adjust up
(if needed) to the square footage (or square meters) of the indoor area.
HIGH MODE:
The unit’s display shows the fan speed
(low to high), the purifier setting (1 bar
to 12 bars), and the purifier coverage in
square feet, for U.S. models, and square
meters, for international units.
Purifier SettingFan Speed Purifier Coverage
NORMAL MODE:
The unit’s display shows the fan speed
(low to high) and NORMAL to indicate that
the ActivePure® (RCI) Cell and ionization
are both functioning normally.
ActivePure® Cell and IonizationFan Speed
“Unoccupied areas” includes pets. Some pets, like humans, may experience adverse reactions
from exposure to increased levels of ozone and should not be present during AWAY MODE
operation.
4. To operate the AWAY MODE feature, in unoccupied areas only,* press the Away Mode button on remote control
until the desired time is reached (2, 4, 6, or 8 hours). The unit will display AWAY MODE and the remaining time. To
interrupt the AWAY MODE, press the Normal/High button.
Away Mode
Fan Speed (Max) Time Remaining
AWAY MODE:
The fan will show maximum, and AWAY
MODE will replace the purifier setting. The
amount of time remaining will depend on
how long you have selected for the AWAY
MODE function to operate. The colon (:)
will flash to indicate time being counted
down.
If you are operating your central heating and air conditioning fan, or other ventilation system,
continuously, set the coverage up to the total ventilated indoor area. Otherwise, set the coverage
up to the size of the room. Do not exceed the size of the ventilated indoor area when setting the
purifier level.
NOTE:
NOTE: