ActronAir LM-ZC-2W User Manual

Operation Manual
Zone Controller
Operation Manual LM-ZC-2 Wall Controller
Document No. 0525-082 Ver. 1 190918
Page 6
07. Turning Zone Controller On
Zone Controller
1. Turn the system On by pressing the Button on the master Wall Controller LM7-2* or LM24-2*.
2. To turn the Zone On, press the Button on Zone Controller. Alternatively, press the designated zone on the Master
Wall Controller. Zone Controller display will show the Set Temperature, ZONE and ESP AUTO.
3. Set the desired temperature by pressing either the or Buttons ^ on the zone controller.
• For a warmer room temperature, press the Button.
• For a cooler room temperature, press the Button
NOTES
• ^ Zone Controller temperature setting can only be adjusted 2
0
C below or above the Master Wall Controller setpoint
temperature. This is a factory set limit, which is recommended in order to maintain system accuracy and maximize
efficiency.
• Wall Controller shown above is LM7-2*, same procedure applies with LM24-2* model.
• * Available in White (LM7-2W/LM24-2W)and Grey (LM7-2G/LM24-2G) variant colours.
08. ESP Auto Mode
Zone Controller
Indications of COOL or HEAT will show zone conditioning.
(When zone damper is providing warm or cold air to your
zone).
1. Press the Button on until ESP AUTO appears on the display.
2. Set the desired temperature by pressing the or Buttons on the zone controller.
• For a warmer room temperature, press the Button.
• For a cooler room temperature, press the Button

ActronAir LM-ZC-2W Specifications

General

Brand	ActronAir
Model	LM-ZC-2W
Category	Controller
Language	English