Service Bulletin 18-037
July 16, 2018 Version 1
2019 MDX: TQI and New Model Service Information
AFFECTED VEHICLES
Year Model Trim Level
2019 MDX 2WD SH-AWD
®
Base Base
with Technology Package with Technology Package
with Technology Package And
Entertainment Package
with Technology Package And Entertainment Package
with A-Spec Package
with Advance Package with Advance Package
with Advance Package And
Entertainment Package
with Advance Package And Entertainment Package
INTRODUCTION
This bulletin covers the total quality inspection (TQI) of the 2019 MDX. It includes these procedures:
1. Remove the Exterior Protective Coatings
2. Install the Fuse
3. Remove the Interior Protective Coverings
4. Install the Floor Mats
5. Check the Battery
6. Install the Body Plugs
7. Install the Front License Plate Holder and Rear License Plate Bolts
8. Set the Tire Pressures, and Initiate the TPMS
9. Do the PCM Idle Learn Procedure
10. Activate the Audio Unit
11. Set the Clock (Trim Levels Without Navigation)
12. Set the Compass Zone (Trim Levels Without Navigation)
13. Check the Compass Calibration (Trim Levels Without Navigation)
14. Check/Refresh the SiriusXM
®
Radio Dealer Demo Service (Except Alaska and Hawaii)
15. Check Driver Assistance Indicators
16. Check the Head-Up Warning (HUW) Indicator (If Equipped)
17. Check Bluetooth
®
HandsFreeLink
®
(HFL)
CLIENT INFORMATION:The information in this bulletin is intended for use only by skilled technicians who have the proper tools, equipment, and
training to correctly and safely maintain your vehicle. These procedures should not be attempted by “do-it-yourselfers,” and you should not assume
this bulletin applies to your vehicle, or that your vehicle has the condition described. To determine whether this information applies, contact an
authorized Acura automobile dealer.
©
2018 American Honda Motor Co., Inc. — All Rights Reserved Page 1 of 13
To Next Page
Need help?
General
