Service Station Procedures
3. Lift the engine cover.
4. NSX-T
Pull the support rod out of its clip
and insert the end into the square
hole in the engine cover bracket.
Except NSX-T
Pull the support rod out of its clip
and insert the end into the square
hole in the window latch bracket.
To Close the Rear Window:
Snap the support rod back into the
clip and lower the engine cover or
roof holder. Pull the rear window
down until it is resting on the body,
then push on the center of the back
edge until it latches. Make sure it is
securely closed before driving away.
Oil Check
Check the engine oil level every time
you fill the car with fuel. Wait a few
minutes after turning the engine off
before you check the oil.
1. Remove the dipstick (orange
handle).
CONTINUED
Before Driving
DIPSTICK
ENGINE COVER
SUPPORT ROD
NSX-T
ENGINE COVER
NSX
To Next Page
Loading...
Need help?
General
