Drive Belts, Timing Belt
Drive Belts
You should check the condition of
the two engine belts every 2 years.
Examine the edges of each belt for
cracks or fraying. Check the tension
of each belt by pushing on it at the
point shown in the diagram.
The belts should have the following
"play" or deflection.
Alternator belt:
0.
4
— 0.53 in (11 — 13.5 mm)
Compressor belt:
0.
4
— 0.5 in (10 — 12 mm)
If you see signs of wear or looseness,
have your dealer adjust or replace
the belts.
Timing Belt
The timing belt should normally be
replaced at the intervals shown in
the maintenance schedule.
Replace this belt at 60,000 miles (U.S.)
or 100,000 km (Canada) if you
regularly drive your car in one or
more of these conditions:
In very high temperatures
(over 110°F, 43°C).
In very low temperatures
(under — 20°F, — 29°C).
Maintenance
COMPRESSOR BELT
ALTERNATOR BELT
To Next Page
Loading...
Need help?
General
