Troubleshooting
Problem
Possible Solution[s]
Relocate the alarm clock and/or the wireless
sensor. Both units must be within 100 feet
from each other. Make sure both units are
Bad Temperature
placed at least 3 feet from other electronic
Reception
appliances and devices that may interfere
with the wireless communication [such as
T Ill
TVs, microwaves, computers etc]. NOTE: It
no bars
may take up to 20 minutes for the alarm clock
to resynchronize with the sensor when
batteries are replaced.
If wireless reception is bad [no bars]. see
No Outdoor
"Bad Reception" section above. The wireless
Temperature Display
ID setting on each unit must match for both
[no communication]
units to communicate properly. See ··set
Wireless ID" on the next page.
Check that the Alarm is turned on; the alarm
time display area will read ""Alarm on·· and a
bell indicator will be vi sable to the right of the
Alarm Does
current time display.
not Sound
Check that the alarm time is set to the
desired wake up time, and that AM/PM is
appropriately selected for your desired
wake up time.
Main Unit
Make certain that the batteries are installed
Display Not Working
correctly. The batteries may need replacing.
ACU
►
RITE.
Product Registration
DESIGNEDTO WORK FOR YOU"
To receive product information, register
your product online. It's quick and easy!
Log on to http://www.chaneyinstrument.com/product_reg.htm
- 6 -
Set Wireless ID
This wireless thermometer
uses long range 433mhz
radio frequency for
communication.
In the event that you have
reception problems due to
interference, both the alarm
clock and the wireless
sensor have a selectable
wireless ID. The ID switches
are located within the
battery compartments of
the alarm clock and the
wireless sensor.
You may choose A, B or C;
but both the alarm clocks'
and the wireless sensors'
both wireless ID's
IDs must match for
must match
successful synchronization.
( 6 • PRODUCT SPECIFICATIONS
)
Measurement Ranges
Temperature
Main Unit: 32°F to 122°F / o°C to 50°C
Wireless Sensor: -40°F to 158°F / -40°C to 70°C
Specifications
Power Requirements
Main Unit: 3 x ""AA" alkaline or lithium batteries [not included)
Wireless Sensor: 2 x ""AA" alkaline or lithium batteries [not included)
Wireless Communication
Rdio Frequency: 433 mhz
Transmission Intervals: every 16 seconds
- 7 -
To Previous Page
Loading...
