Troubleshooting
Clock is too dark,
hard to read or
doesn’t work
• Verify that the batteries are installed correctly. Batteries
may need to be replaced.
• The optimum viewing angle for this product is from slightly
above it.
• Reset the unit by pressing the reset button, located in the
battery compartment. This resets the alarm to the original
factory settings. Time and date will need to be entered
after a reset.
Inaccurate
temperature
• Verify the clock is placed out of direct sunlight and away
from any heat sources or vents (see page 6).
Atomic signal or time
syncing problems
• For additional troubleshooting, please visit:
http://www.nist.gov/pml/div688/grp40/radioclocks.cfm
If your AcuRite product does not operate properly after trying
the troubleshooting steps, visit www.AcuRite.com or call
(877) 221-1252 for assistance.
8
To Next Page
Loading...
