14.0 ERROR MESSAGES
During the initial power-on testing or during the operation the scale may
show an error message. The error messages are described below.
ERROR CODE DESCRIPTION POSSIBLE CAUSES
A continuous beep is
heard.
Weight on the pan exceeds the
capacity of the scale. Remove
the weight from the pan.
If the selected mass is
less than 10% or more
than 20% of the capacity
of the scale, an error
message “CALEr” will be
displayed and the scale
will return to zero.
Incorrect calibration mass.
Repeat the process correctly.
If an error message is shown, repeat the procedure that caused the message
such as turning the scale on, calibration or any other functions. If the error
message is still shown, contact your supplier for further support.
15.0 REPLACEMENT PARTS AND ACCESSORIES
If you need to order any accessories and spare parts, contact your
dealer or Adam Equipment. A partial list of such items is as follows-
Accessories Part Number
7954
Hard carry case (For Standard CPWplus
models only)
Printer 8023
RS-232 cable 9014
Non-slip mats (For CPWplus L models only)
9013
Spare Parts Part Number
Power Supply Adapter 7973
Keypad overlay 7960
7972
Stainless Steel Pan for CPWplus
Stainless Steel Pan for CPWplus M
9011
Stainless Steel Pan for CPWplus L
9010
Replacement Lead-Acid Battery for
CPWplus M & CPWplus L
9012
© Adam Equipment Company 2008
25
To Next Page
Loading...
Need help?
General
