3.3 SETTING UP
3.3.1 SETTING UP THE STANDARD CPWplus SERIES
1 Remove the parts from the packing
carefully. Place the base on a rigid surface.
Place the Stainless Steel pan on the base, if
it not already assembled.
2 The indicator is separately packed and
comes attached to a bracket with the help of
two thumb screws.
To adjust the angle of the indicator, use the
two thumb screws on the side of the bracket
that connects the indicator.
3 Connect the cable attached to the base
to the connector at the rear of the indicator.
Tighten the ferrule to secure the cable.
4 Power can be supplied using the adapter
delivering 12 VAC 150 mA minimum or using
batteries inside the scale unit (6 x AA size).
Remove the cover from the battery
compartment under the scale. Install six AA
size batteries as shown below.
The alkaline batteries are suggested for use
for best life.
© Adam Equipment Company 2008
7
NOTE: When moving the scale, take care to
prevent bending of the cable and connector
too much as over a period of time this can
weaken the wires in the connector and
cause malfunction.
MOUNTING THE INDICATOR- The indicator attached to the bracket can be mounted in the
following 3 ways. To adjust the angle of the indicator, use the two thumb screws on the side of the
bracket that connects the indicator.
1. Place it on the work bench- Simply place the indicator attached to the bracket on the work
bench at an angle.
2. Attach it to the base of the scale- There are two thumb screws on the base (opposite to the
Power input and RS-232 ports). Remove them from the base and use them to attach the
bracket to the base.
3. Mount it on the wall- Use two suitable screws (not supplied) to fix the bracket to the wall.
Thumb Screw
Bracket
Connector
on the
Indicator
Ferrule
6 X "AA" Alkaline
Connector
attached to
the cable
To Next Page
Loading...
Need help?
General
