Advanced Control Equipment (ACE2)
96A0357 Rev. F
Troubleshooting
© ADB Airfield Solutions All Rights Reserved34
Insulation Alarm
Somewhere on the load a wire has become
exposed, allowing current to ground out.
The Insulation Alarm threshold is too low.
Check load for damaged lines.
Reset the Insulation threshold using the
display in stand-alone. (refer to Figure 8) or
use ACLMS configuration.
In Local Control The regulator is set in Local Control mode. N/A
Table 7: Error Messages
Error Message Possible Cause Corrective Action
To Next Page
Loading...
